Dev.to WebDev 🛠 Dev 👁 0 📖 1 min read

How to Trim Audio for a Juniper Tide Video — Free, in Your Browser

A Juniper Tide video lives or dies by its sound. Waves, wind, a voiceover recorded on the shore — the raw audio is rarely ready to publish. Here is a quick way to clean it up in the browser, free, with no software to ins

A Juniper Tide video lives or dies by its sound. Waves, wind, a voiceover recorded on the shore — the raw audio is rarely ready to publish. Here is a quick way to clean it up in the browser, free, with no software to install.

1. Open your clip in AudioCutter

Go to AudioCutter and open the audio from your Juniper Tide video. Everything runs in the browser, so your file never leaves your device. MP3, WAV, and M4A all work.

2. Trim the rough edges

Drag the handles to cut the wind noise at the start and the footsteps at the end. If someone talks over the best part, split the clip and remove just that section — the rest stays intact.

3. Pull out the highlight

Find the 20–30 seconds that matter most — the clearest wave sound, the funniest line, the calmest moment — and cut around it. A short highlight gets watched; a long raw take gets skipped.

4. Smooth the joins with fades

A one-second fade-in and fade-out hides every cut. Without fades, a trimmed clip sounds chopped; with them, it sounds intentional.

5. Export as MP3 and listen once

Export, play the whole clip from start to finish, and make sure nothing important is missing. Then drop it into your video editor. Five steps, a few minutes, no cost.

Disclosure: I am the developer of AudioCutter, a free online audio cutter at https://audiocutter.me/ that trims audio in your browser without installing software or uploading files.

📰 Read the original article on Dev.to WebDev

Originally published by Dev.to WebDev. Aggregated on AIWithGhost for educational purposes — full credit and traffic to the original publisher.