Dev.to WebDev 🛠 Dev 👁 0

How to Trim Audio for a Fern Brook Video — Free, in Your Browser

Planning a video about Fern Brook? The footage is usually the easy part — the audio is what takes time. Long pauses, wind noise at the start, a rambling intro before the good part begins. You can fix all of that in a cou

Planning a video about Fern Brook? The footage is usually the easy part — the audio is what takes time. Long pauses, wind noise at the start, a rambling intro before the good part begins. You can fix all of that in a couple of minutes with a free browser tool, no install and no upload.

Step 1: Open AudioCutter

Go to AudioCutter and click to open your audio file. It runs entirely in your browser, so your recording never leaves your computer.

Step 2: Find the part worth keeping

Drag the handles on the waveform to mark the section you want. Listen once through — cut the dead air at the beginning and the trailing chatter at the end first.

Step 3: Smooth the edges

Add a short fade-in at the start and a fade-out at the end so the clip does not begin or stop abruptly over your video.

Step 4: Export and drop it in

Export as MP3, then place the trimmed clip under your Fern Brook footage. The whole job takes less time than re-recording a single take.

Disclosure: I built AudioCutter, a free online audio cutter at https://audiocutter.me/. I use it for exactly this kind of quick trim.

📰 Read the original article on Dev.to WebDev

Originally published by Dev.to WebDev. Aggregated on AIWithGhost for educational purposes — full credit and traffic to the original publisher.