Dev.to WebDev 🛠 Dev 👁 0 📖 1 min read

How to Trim Audio for a Cedar Brook Video — Free, in Your Browser

Cedar Brook is the kind of place that makes you want to record everything — the water, the birds, the quiet between them. The trouble is that a raw recording is almost never shareable as-is: there is dead air at the star

Cedar Brook is the kind of place that makes you want to record everything — the water, the birds, the quiet between them. The trouble is that a raw recording is almost never shareable as-is: there is dead air at the start, a loud splash in the middle, and a few seconds of fumbling at the end. Here is how to trim it down to the good part, free, in your browser, with AudioCutter (https://audiocutter.me/).

First, open AudioCutter and drop your audio file onto the page. It accepts MP3, WAV, M4A and other common formats, and the file is processed locally in your browser rather than uploaded anywhere.

Next, drag the selection handles on the waveform to mark exactly the section you want. Play it back once so you can hear where the splash or the pause sits, then tighten the selection around the clean stretch.

If the clip starts or ends abruptly, add a short fade-in or fade-out — two seconds is usually enough to make it sound natural.

Finally, export as MP3 and use the trimmed clip in your video. A 30-second clip of clear brook sound will do far more for your video than three unedited minutes.

Disclosure: I am the developer of AudioCutter (https://audiocutter.me/), a free browser-based audio cutter. This tutorial shows the workflow I built it for.

📰 Read the original article on Dev.to WebDev

Originally published by Dev.to WebDev. Aggregated on AIWithGhost for educational purposes — full credit and traffic to the original publisher.